208, "Select the controller that you will physically attach your new hard drive to. Press \"Next\" to continue."
209, "Select the option that describes how you will physically attach your new hard drive to your computer.\n\nA custom installation manual will be created for you based on this selection to help you physically attach your new hard drive to the computer.\n \nPress the help button to view more information about the choices."
210, "Warning: This drive is already setup with one or more partitions. Any existing data on the partitions will be destroyed."
211, "&Continue with selected option and erase existing data."
212, "GBYTES"
213, "(FULL)"
214, "Existing &motherboard controller"
215, "Add-on ATA controller card &already installed in your computer"
216, "Add-on ATA controller card that &will be installed in your computer"
217, "Unknown Controller"
218, "You are now ready to install your new hard drive. Shutdown your system and follow the custom installation instructions provided on the previous page. For more information about installing your new hard drive, refer to your computer and hard drive documentation."
219, "Shutdown your system and install your new drive."
220, "An error occurred while printing the Custom Installation Manual. Check to make sure all printer cables are attached properly and that your printer is turned on.\n\nClick 'Retry' to try again or 'Cancel' to cancel printing."
221, "Print Error"
222, "Install New Drive"
223, "Disk Manager has detected your new drive in the system and will continue setup.\n\nDrive: %s\nPosition: %s"
